125
Model material surface
finish is poor on
downward facing
surfaces.
Support material
re
moves too easily.
The tip-to-tip calibration is not set
co
rrectly.
Repeat tip-to-tip calibration.
Material is oozing. Dryer failure.
Call Customer Support (see
“Getting
Help” on page 122
for contact
information).
Moisture in the canister.
Air pressure low.
Call Customer Support (see
“Getting
Help” on page 122
for contact
information).
Oven not maintaining
te
mperatures.
Heater failure.
Call Customer Support (see
“Getting
Help” on page 122
for contact
information).
Oven door open. Close the oven door; the heater turns off
wh
ile the door is open.
Oven door not sealing with oven
fa
scia panel.
Call Customer Support (see
“Getting
Help” on page 122
for contact
information).
Information Available If a Job Fails While Building:
If a job fails, you can determine the last layer built by selecting the “previous job” from the Operator
To
uchscreen.
Condition Possible Cause Remedy
To Next Page
Loading...
