Engine General Information and Diagnosis: 1A-32
P0105-L for IAP sensor (No.1) (Use of SDS)
Step Action Yes No
1 1) Click the data monitor button (1).
2) Check the manifold absolute pressure 1 data.
Approx. –20 kPa (–0.2 kgf/cm
3
, –2.8 psi) and less OK?
Go to Step 2. Go to Step 4.
2 1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-9)”.
3) Check the IAP sensor (No.1) coupler for loose or poor
contacts.
If OK, then check the IAP sensor (No.1) lead wire
continuity.
Go to Step 3. R and W/Bl wire open,
W/Bl wire shorted to the
ground.
1
I718H1110251-01
I718H1110163-02
I718H1110257-01
To Next Page
Loading...
