6B-9 Steering / Handlebar:
Handlebars
• Tighten the handlebar holder set nuts to the specified
torque.
Tightening torque
Handlebar holder set nut (a): 45 N·m (4.5 kgf-m,
32.5 lb-ft)
Inspection after installation
• Check the steering tension. Refer to “Steering Tension
Adjustment (Page 6B-10)”.
Steering Related Parts Inspection
B718H16206011
Refer to “Steering Removal and Installation (Page 6B-
6)”.
Inspect the removed parts for the following
abnormalities.
• Distortion of the steering stem
• Bearing wear or damage
• Abnormal bearing noise
• Race wear or damage
• Bearing lower seal damage
• Rubber seat and damper bushing wear or damage
If any abnormal points are found, replace defective parts
with new ones.
Steering System Inspection
B718H16206012
Refer to “Steering System Inspection in Section 0B
(Page 0B-20)”.
Steering Stem Bearing Removal and Installation
B718H16206008
Removal
1) Remove the steering stem lower bracket. Refer to
“Steering Removal and Installation (Page 6B-6)”.
2) Remove the dust seal (1) and steering stem upper
bearing (2).
(a)
I718H1620035-04
I718H1620026-02
I718H1620042-04
2
1
I718H1620039-02
To Next Page
Loading...
