Suzuki GSF1250 - Front Brake Hose Removal and Installation

Brake Control System and Diagnosis: 4A-12
8) Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
Air bleeder valve (Rear brake) (a): 6.0 N·m (0.6
kgf-m, 4.5 lb-ft)
9) Fill the reservoir with brake fluid to the upper mark of
the reservoir.
Front Brake Hose Removal and Installation
B718H14106009
GSF1250/S
Removal
1) Drain brake fluid. Refer to “Brake Fluid Replacement
(Page 4A-10)”.
2) Remove the front brake hoses as shown in the front
brake hose routing diagram. Refer to “Front Brake
Hose Routing Diagram (Page 4A-1)”.
Installation
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
1) Install the front brake hose as shown in the front
brake hose routing diagram. Refer to “Front Brake
Hose Routing Diagram (Page 4A-1)”.
2) Bleed air from the front brake system. Refer to “Air
Bleeding from Brake Fluid Circuit (Page 4A-8)”.
GSF1250A/SA
Removal
1) Remove the seat and right frame cover. Refer to
“Exterior Parts Removal and Installation in Section
9D (Page 9D-6)”.
2) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
3) Drain brake fluid. Refer to “Brake Fluid Replacement
(Page 4A-10)”.
4) Remove the battery and battery case. Refer to “ABS
Control Unit/HU Removal and Installation in Section
4E (Page 4E-74)”.
5) Remove the fender lower cover (1).
6) Remove the front brake hose as shown in the front
brake hose routing diagram. Refer to “Front Brake
Hose Routing Diagram (Page 4A-1)”.
Installation
CAUTION
!
The seal washers should be replaced with the
new ones to prevent fluid leakage.
1) Install the front brake hose as shown in the front
brake hose routing diagram. Refer to “Front Brake
Hose Routing Diagram (Page 4A-1)”.
2) Bleed air from the front brake system. Refer to “Air
Bleeding from Brake Fluid Circuit (Page 4A-8)”.
3) Reinstall the removed parts.
(a)
I718H1410047-01
I718H1410067-02
1
I718H1410019-03