4A-11 Brake Control System and Diagnosis:
7) Close the air bleeder valve and disconnect the clear
hose.
Tightening torque
Air bleeder valve (Front brake) (a): 7.5 N·m (0.75
kgf-m, 5.5 lb-ft)
8) Fill the reservoir with brake fluid to the upper mark of
the reservoir.
9) Install the reservoir cap.
Rear Brake
1) Place the motorcycle on a level surface.
2) Remove the right frame cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-6)”.
3) Remove the brake fluid reservoir cap and
diaphragm.
4) Suck up the old brake fluid as much as possible.
5) Fill the reservoir with new brake fluid.
BF: Brake fluid (DOT 4)
6) Connect a clear hose to the air bleeder valve and
insert the other end of the hose into a receptacle.
7) Loosen the air bleeder valve and pump the brake
pedal until the old brake fluid flows out of the brake
system.
(a)
(a)
I718H1410044-01
I718H1410066-01
I718H1410045-01
I718H1410041-01
I718H1410068-02
To Next Page
Loading...
