Suzuki GSF1250 - Wiring Harness Routing Diagram

Wiring Systems: 9A-8
Wiring Harness Routing Diagram
B718H19102003
6
1
5
“B”
“C”
“A”
2
3
7
4
“a”
“a” “a”
8
9
11
10
12
I718H1910910-05
1. Battery 9. Brake hose (ABS) (GSF1250A/SA only)
2. EVAP purge control valve (E-33 only) 10. Rear wheel speed sensor coupler (GSF1250A/SA only)
3. Clamp (GSF1250/A only)
: Pass through the speed meter lead right side of ignition switch.
Cut the tip of clamp after clamping.
11. Clamp
: Clamp the lead wire and ABS brake hose (GSF1250A/SA).
4. Clamp (GSF1250S/SA only)
: Clamp the handle switch right and left lead at the middle of blue
taping.
12. Clamp
: Clamp the handle bar lead wires, ignition switch lead wire and front
wheel speed sensor lead wire (GSF1250A/SA).
5. Clamp “A”: Pass through the horn and fan lead wire upper the ABS brake hose
(GSF1250A/SA).
Pass through the EVAP purge control valve lead wire upper the clutch
hose (E-33 only).
6. Clamp
: Clamp tip backward.
“B”: Pass through the lead wire under the water hoses.
7. Clamp
: Cut the tip of clamp after clamping.
“C”: Slack the lead wire downward.
8. Wring harness
: Be careful not to pinch the wring harness with the frame and fender.
“a”: 5 – 10 mm (0.2 – 0.4 in)