Suzuki GSF1250 - Gearshift Linkage Inspection

5B-18 Manual Transmission:
• Install the gearshift shaft assembly (6) and washers
(7) as shown.
NOTE
Pinch the gearshift arm stopper (8) with
return spring ends “F”.
• Install a new snap ring (10).
Special tool
: 09900–06107 (Snap ring pliers)
• After installing the gearshift lever, check the gearshift
lever height. Refer to “Gearshift Lever Height
Inspection and Adjustment (Page 5B-14)”.
Gearshift Linkage Inspection
B718H15206012
Refer to “Gearshift Shaft / Gearshift Cam Plate Removal
and Installation (Page 5B-15)”.
Gearshift Shaft
Check the gearshift shaft for bend or wear.
Check the return spring for damage or fatigue.
If any defects are found, replace the defective part(-s).
Gearshift Shaft Oil Seal
Inspect the gearshift shaft oil seal lip for damage or
wear. If any defect is found, replace the oil seal with a
new one.
Gearshift Shaft Bearing
Inspect the gearshift shaft bearing for abnormal noise
and smooth rotation. Replace the bearing if there is
anything unusual.
6
7
7
I718H1520058-02
8
“F”
“F”
I718H1520059-02
10
I718H1520060-01
I718H1520061-01
I718H1520062-01
I718H1520063-01