Suzuki GSF1250 - Page 589

Manual Transmission: 5B-17
• Check the gearshift cam stopper moves smoothly.
• Locate the gearshift cam in the neutral position.
• Install the gearshift cam stopper plate (5).
NOTE
Align the gearshift cam pin “B” with the
gearshift cam stopper plate hole “C”.
• Apply a small quantity of thread lock to the gearshift
cam stopper plate bolt and tighten it to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift cam stopper plate bolt (c): 13 N·m (1.3
kgf-m, 9.5 lb-ft)
• Apply a small quantity of thread lock to the gearshift
shaft end bolt and tighten it to the specified torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Gearshift shaft end bolt (d): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
NOTE
The concave side of washer faces outside.
• When installing the gearshift shaft return spring,
position the stopper “D” of gearshift arm between the
shaft return spring ends “E”.
5
“B”
“C”
I718H1520054-01
(c)
I718H1520055-02
(d)
I718H1520056-02
I718H1520084-01
“D”
“E”
I718H1520057-01