9B-12 Lighting Systems:
3) Inspect the turn signal switch for continuity with a
tester. If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the turn signal switch inspection,
reinstall the removed parts.
Passing Light Switch Inspection
B718H19206021
Inspect the passing light switch in the following
procedures:
1) Remove the right frame head cover. (GSF1250/A)
Refer to “Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the passing light switch for continuity with a
tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the passing light switch inspection,
reinstall the removed parts.
Dimmer Switch Inspection
B718H19206022
Inspect the dimmer switch in the following procedures:
1) Remove the right frame head cover. (GSF1250/A)
Refer to “Exterior Parts Removal and Installation in
Section 9D (Page 9D-6)”.
2) Disconnect the left handlebar switch coupler (1).
3) Inspect the dimmer switch for continuity with a tester.
If any abnormality is found, replace the left
handlebar switch assembly with a new one.
Refer to “Handlebar Removal and Installation in
Section 6B (Page 6B-3)”.
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
4) After finishing the dimmer switch inspection, reinstall
the removed parts.
L
PUSH
R
B/G B/Br B
Color
Position
I649G1920037-02
1
I718H1920035-01
PUSH
Position
Color
G/B Dg
I649G1920038-02
1
I718H1920035-01
Position
Color
Dbr Dg G/B
HI
LO
I718H1920046-04
To Next Page
Loading...
