Suzuki GSF1250 - Special Tools and Equipment; Recommended Service Material

Engine Mechanical: 1D-85
NOTE
The specified tightening torque is also described in the following.
“Throttle Body Components (Page 1D-7)”
“Throttle Body Construction (Page 1D-8)”
“Engine Assembly Installation (Page 1D-21)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque Specifications in Section
0C (Page 0C-7)”.
Special Tools and Equipment
Recommended Service Material
B718H11408001
Balancer shaft mounting bolt 10 1.0 7.0 )(Page 1D-65)
Oil cooler union bolt 70 7.0 50.5 )(Page 1D-67)
Oil pressure switch 14 1.4 10.0 )(Page 1D-67)
Oil Pressure switch lead wire mounting bolt 1.5 0.15 1.1 )(Page 1D-68)
Gear position switch mounting bolt 6.5 0.65 4.7 )(Page 1D-68)
Water pump mounting bolt 10 1.0 7.0 )(Page 1D-69)
Gearshift cam stopper bolt 10 1.0 7.0 )(Page 1D-69)
Gearshift cam stopper plate bolt 13 1.3 9.5 )(Page 1D-70)
Gearshift arm stopper 19 1.9 13.5 )(Page 1D-70)
Oil pump mounting bolt 10 1.0 7.0 )(Page 1D-71)
Conrod cap bolt 21 N⋅m (2.1 kgf-m, 15.0 Ib-ft) then turn in 1/
4 (90°) turn.
)(Page 1D-75) /
)(Page 1D-76)
Crankcase journal bolt (Initial) 18 1.8 13.0 )(Page 1D-79)
Crankcase journal bolt (Final) 32 3.2 23.0 )(Page 1D-79)
Fastening part
Tightening torque
Note
N⋅mkgf-mlb-ft
Material SUZUKI recommended product or Specification Note
Grease SUZUKI SUPER GREASE A or
equivalent
P/No.: 99000–25010 )(Page 1D-13) /
)(Page 1D-23) /
)(Page 1D-41) /
)(Page 1D-66) /
)(Page 1D-66) /
)(Page 1D-67) /
)(Page 1D-68) /
)(Page 1D-69) /
)(Page 1D-71)
Molybdenum oil MOLYBDENUM OIL SOLUTION — )(Page 1D-28) /
)(Page 1D-29) /
)(Page 1D-42) /
)(Page 1D-74)
Sealant SUZUKI BOND No.1215 or
equivalent
P/No.: 99000–31110 )(Page 1D-63) /
)(Page 1D-66) /
)(Page 1D-68)
SUZUKI BOND No.1207B or
equivalent
P/No.: 99000–31140 )(Page 1D-67)
SUZUKI Bond 1207B or equivalent P/No.: 99000–31140 )(Page 1D-34) /
)(Page 1D-35)