Wheels and Tires: 2D-22
Air Valve
Inspect the air valve for peeling and damage. If any
defect is found, replace the air valve with a new one.
Refer to “Air Valve Removal and Installation (Page 2D-
22)”.
Inspect the valve core seal (1) for wear and damage. If
any defect is found, replace the valve core with a new
one. Refer to “Air Valve Removal and Installation
(Page 2D-22)”.
Air Valve Removal and Installation
B718H12406013
Removal
1) Remove the wheel assembly. Refer to “Front Wheel
Assembly Removal and Installation (Page 2D-6)”
and “Rear Wheel Assembly Removal and Installation
(Page 2D-16)”.
2) Remove the tire. Refer to “Tire Removal and
Installation (Page 2D-20)”.
3) Remove the air valve (1) from the wheel.
Installation
Install the air valve in the reverse order of removal. Pay
attention to the following points:
• Any dust or rust around the valve hole (1) must be
cleaned off.
• Install the air valve (2) in the wheel (3).
CAUTION
!
• Be careful not to damage the lip (4) of the
valve.
• Replace the air valve with a new one.
NOTE
To properly install the valve into the valve
hole, apply a special tire lubricant or neutral
soapy liquid to the valve.
1. Seal
I649G1240044-02
1
I649G1240045-02
1
I649G1240046-02
2. Valve 3. Wheel 4. Valve lip
1
I718H1240054-01
3
2
4
I718H1240055-01
To Next Page
Loading...
