1H-5 Ignition System:
• Install the ignition coil/plug caps and connect their
lead wire couplers.
CAUTION
!
Do not hit the ignition coil/plug cap with a
plastic hammer when installing it.
Spark Plug Inspection and Cleaning
B718H11806003
Refer to “Spark Plug Inspection and Cleaning in Section
0B (Page 0B-4)”.
Ignition Coil / Plug Cap Inspection
B718H11806004
Refer to “Electrical Components Location in Section 0A
(Page 0A-8)”.
Ignition Coil Primary Peak Voltage
1) Remove the fuel tank. Refer to “Fuel Tank Removal
and Installation in Section 1G (Page 1G-9)”.
2) Disconnect all ignition coil/plug cap and PAIR control
solenoid valve coupler (1). Refer to “Ignition Coil /
Plug Cap and Spark Plug Removal and Installation
(Page 1H-4)”.
3) Connect new spark plug to each ignition coil/spark
plug cap.
4) Connect all the ignition coil/plug cap lead wire
couplers to the ignition coil/plug caps respectively,
and ground them on the cylinder head.
NOTE
Be sure that all the spark plugs are
connected properly and the battery used is in
fully-charged condition.
INCORRECT
I718H1180012-01
I718H1180013-01
1
I718H1180014-01
I718H1180015-01
To Next Page
Loading...
