Engine General Information and Diagnosis: 1A-34
3 1) Connect the ECM coupler.
2) Turn the ignition switch ON.
3) Measure the input voltage at the B wire and ground with
the needle pointed probes.
If OK, the measure the input voltage at the B wire and B/
Br wire.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
IAP sensor input voltage (No.1)
4.5 – 5.5 V
((+) terminal: B – (–) terminal: Ground,(+) terminal: B
– (–) terminal: B/Br)
Is the voltage OK?
Go to Step 4. Open or short circuit in
the B wire or B/Br wire.
Step Action Yes No
(A)
I718H1110258-01
To Next Page
Loading...
