Engine Mechanical: 1D-31
Water Hose
• Install the water hoses (1). Refer to “Water Hose
Routing Diagram in Section 1F (Page 1F-3)”.
Exhaust Pipe / Muffler
• Install the exhaust pipe assembly (1), muffler and
radiator (2). Refer to “Exhaust Pipe / Muffler Removal
and Installation in Section 1K (Page 1K-3)” and
“Radiator / Cooling Fan Motor Removal and
Installation in Section 1F (Page 1F-5)”.
Camshaft
• Turn the crankshaft clockwise and align the match
mark “A” on the crankshaft with the mating surfaces
“B” of crankcases.
CAUTION
!
• Pull the cam chain upward, or the chain
will be caught between crankcase and cam
drive sprocket.
• To adjust the camshaft timing correctly, be
sure to align the match mark “A” with the
mating surfaces “B” and hold this position
when installing the camshafts.
• Before replacing the camshafts on cylinder head,
apply engine oil to their journals and cam faces.
• Apply engine oil to the camshaft journal holders.
NOTE
• Before installing the camshaft, check that
the tappets are installed correctly.
• The camshafts are identified by the
embossed letters.
• Pull the cam chain lightly.
• The exhaust camshaft sprocket has an arrow marked
“1” “C”. Turn the exhaust camshaft so that the arrow is
aligned with the gasket surface of the cylinder head.
• Engage the cam chain with the exhaust camshaft
sprocket.
1
I718H1140060-01
1
2
I718H1140061-01
“A”
“B”
I718H1140062-02
I718H1140063-01
“C”
I718H1140064-01
To Next Page
Loading...
