Engine Mechanical: 1D-41
3) Remove the valve spring retainer (4) and valve
spring (5).
4) Pull out the valve (6) from the combustion chamber
side.
5) Remove the oil seal (7) and spring seat (8).
6) Remove the other valves in the same manner as
described previously.
7) Remove the water outlet pipes (9).
8) Remove the intake pipes.
9) Remove the oil gallery plugs (cylinder head) (10).
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Tighten the oil gallery plugs (cylinder head) to the
specified torque.
CAUTION
!
Replace the gasket with new ones.
Tightening torque
Oil gallery plug (cylinder head) (a): 10 N·m (1.0
kgf-m, 7.0 lb-ft)
• Apply grease to O-ring of the intake pipe.
CAUTION
!
Replace the O-rings with new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5
6
4
I718H1140101-01
7
8
I718H1140102-01
9
I718H1140103-01
I718H1140105-01
10
10
I718H1140106-01
(a)
(a)
I718H1140107-01
I718H1140109-01
To Next Page
Loading...
