Engine Mechanical: 1D-49
3) Remove the water jacket plugs (4).
Assembly
Assembly is in the reverse order of disassembly. Pay
attention to the following points:
• Tighten the water jacket plugs to the specified torque.
CAUTION
!
Replace the gaskets with new ones.
Tightening torque
Water jacket plug (a): 30 N·m (3.0 kgf-m, 21.5 lb-
ft)
• Apply engine coolant to O-ring of water inlet
connector.
CAUTION
!
Replace the O-ring with a new one.
• Tighten the water inlet connector bolts to the specified
torque.
CAUTION
!
Make sure that the “up” mark “A” face up.
Tightening torque
Water inlet connector bolt (a): 10 N·m (1.0 kgf-m,
7.0 lb-ft)
4
I718H1140133-01
4
4
I718H1140134-01
(a)
(a)
I718H1140135-01
(a)
I718H1140136-01
I718H1140137-01
(a)
(a)
“A”
I718H1140398-01
To Next Page
Loading...
