Ignition System: 1H-10
Installation
Install the ignition switch in the reverse order of removal.
Pay attention to the following points:
• Install the ignition switch and new bolts.
• Tighten each bolt until its head is broken off.
NOTE
The spare ignition switch comes equipped
with the special bolts, however, the bolts are
also individually available as spare parts.
• First tighten the steering stem head nut (1), then
tighten the front fork upper clamp bolts (2).
Tightening torque
Steering stem head nut (a): 65 N·m (6.5 kgf-m,
47.0 lb-ft)
Front fork upper clamp bolt (b): 23 N·m (2.3 kgf-
m, 16.5 lb-ft)
• Tighten the handlebar holder set nuts (3) to the
specified torque.
Tightening torque
Handlebar holder set nut (c): 45 N·m (4.5 kgf-m,
32.5 lb-ft)
• Route the cables, hoses and lead wires. Refer to
“Throttle Cable Routing Diagram in Section 1D
(Page 1D-2)”, “Front Brake Hose Routing Diagram in
Section 4A (Page 4A-1)” and “Wiring Harness Routing
Diagram in Section 9A (Page 9A-8)”.
I718H1180023-01
(a)
1
(b)
2
I718H1180024-04
(c)
3
I718H1180025-02
To Next Page
Loading...
