Suzuki GSF1250 - Page 361

Starting System: 1I-11
3) Remove the idle gear shaft (2) and starter idle gear
(3).
4) Remove the generator rotor assembly (4). Refer to
“Generator Removal and Installation in Section 1J
(Page 1J-4)”.
5) Remove the key (5) and starter driven gear (6).
6) Hold the generator rotor with the special tool and
remove the starter clutch bolts.
Special tool
(A): 09930–44530 (Rotor holder)
7) Remove the one way clutch (7) from the guide (8).
Installation
Install the starter clutch in the reverse order of removal.
Pay attention to the following points:
• When inserting the one way clutch (1) into the guide
(2), fit the flange “A” in the step of the guide (2).
NOTE
Be sure to seat the flange “A” of the one way
clutch (1) to the guide (2).
2
3
4
I718H1190026-01
6
5
I718H1190027-01
(A)
I718H1190028-01
7
8
I718H1190029-01
1
“A”
2
I718H1190030-02
I718H1190031-01