Suzuki GSF1250 - Page 430

2D-19 Wheels and Tires:
2) First install the right wheel bearing, then install the
spacer (1) and left wheel bearing with the special
tools.
Special tool
(A): 09941–34513 (Steering race installer)
(B): 09924–84510 (Bearing installer set)
CAUTION
!
The sealed cover of the bearing must face
outside.
3) Install a new dust seal with the special tool.
Special tool
(C): 09913–70210 (Bearing installer set)
4) Apply grease to the dust seal lip.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
5) Install the rear wheel speed sensor rotor.
(GSF1250A/SA) Refer to “Rear Wheel Speed
Sensor Rotor Removal and Installation in Section 4E
(Page 4E-73)”.
6) Install the rear sprocket mounting drum assembly.
7) Install the rear wheel assembly. Refer to “Rear
Wheel Assembly Removal and Installation
(Page 2D-16)”.
1. Spacer “a”: Clearance
(B)
(A)
I649G1240030-02
Left
Right
Left
Right
(B)
(B)
(A)
“a”
(B)
(A)
1
(B)
I649G1240034-03
(C)
I718H1240042-01
I718H1240043-01
I718H1240053-01