Suzuki GSF1250 - Page 441

Drive Chain / Drive Train / Drive Shaft: 3A-3
10) Loosen the rear axle nut (8).
11) Loosen the chain adjusters (9) to provide additional
chain slack.
12) Remove the engine sprocket (10).
Installation
Install the engine sprocket in the reverse order of
removal. Pay attention to the following points:
• Apply THREAD LOCK SUPER to the driveshaft.
: Thread lock cement 99000–32030 (Thread
Lock Cement Super 1303 or equivalent)
• Tighten the engine sprocket nut (1) to the specified
torque.
Tightening torque
Engine sprocket nut (a): 115 N·m (11.5 kgf-m, 83.0
lb-ft)
• Tighten the speed sensor rotor bolt (2) to the specified
torque.
Tightening torque
Speed sensor rotor bolt (b): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
• Before installing the engine sprocket inner cover,
apply a small quantity of SUZUKI SUPER GREASE to
the clutch push rod.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket inner cover (3).
NOTE
Fit the clamp to the bolt “A”.
• Tighten the speed sensor mounting bolt (4) to the
specified torque.
Tightening torque
Speed sensor bolt (c): 6.5 N·m (0.65 kgf-m, 4.7 lb-
ft)
8
9
I718H1310023-05
10
I718H1310008-02
(a)
1
I718H1310035-02
(b)
2
I718H1310010-02
(C)
4
“A”
3
I718H1310024-02