0B-15 Maintenance and Lubrication:
3) Inspect the clutch hose for crack, damage or clutch
fluid leakage. If it is damaged, replace the clutch
hose with a new one.
4) After finishing the clutch hose inspection, reinstall
the removed parts.
Clutch Hose Replacement
B718H10206014
Replace clutch hose
Every 4 years
Refer to “Clutch Hose Removal and Installation in
Section 5C (Page 5C-5)”.
Clutch Fluid Replacement
B718H10206016
Replace clutch fluid
Every 2 years
Refer to “Clutch Fluid Replacement in Section 5C
(Page 5C-4)”.
Air Bleeding from Clutch Fluid Circuit
Refer to “Air Bleeding from Clutch Fluid Circuit in Section
5C (Page 5C-4)”.
Drive Chain Inspection and Adjustment
B718H10206017
Inspect drive chain
Initially at 1 000 km (600 miles, 2 months) and every
6 000 km (4 000 miles, 12 months) thereafter.
Drive Chain Visual Check
1) With the transmission in neutral, support the
motorcycle using the center-stand and turn the rear
wheel slowly by hand.
2) Visually check the drive chain for the possible
defects listed as follows. If any defects are found, the
drive chain must be replaced. Refer to “Drive Chain
Replacement in Section 3A (Page 3A-7)”.
• Loose pins
• Damaged rollers
• Dry or rusted links
• Kinked or binding links
• Excessive wear
• Improper chain adjustment
• Missing O-ring seals
NOTE
When replacing the drive chain, replace the
drive chain and sprockets as a set.
Drive Chain Length Inspection
1) Loosen the axle nut (1).
2) Loosen the chain adjuster lock-nuts (2).
3) Give tension to the drive chain fully by turning both
chain adjuster bolts (3).
I718H1020035-01
1. O-ring seal 2. Grease
2
1
I649G1020032-02
2
3
13
2
I718H1020036-02
To Next Page
Loading...
