Brake Control System and Diagnosis: 4A-16
2) Remove the reservoir cap (3), plate (4) and
diaphragm (5).
3) Pull out the dust boot (6) and remove the snap ring
(7).
Special tool
: 09900–06108 (Snap ring pliers)
4) Remove the following parts from the master cylinder.
•Piston (8)
• Secondary cup (9)
• Primary cup (10)
• Spring (11)
Assembly
Assemble the master cylinder in the reverse order of
disassembly. Pay attention to the following points:
CAUTION
!
• Wash the master cylinder components with
new brake fluid before reassembly.
• Do not wipe the brake fluid off after
washing the components.
• When washing the components, use the
specified brake fluid. Never use different
types of fluid or cleaning solvents such as
gasoline, kerosine, etc.
• Apply brake fluid to the master cylinder
bore and all of the master cylinder
component to be inserted into the bore.
BF: Brake fluid (DOT 4)
• When installing the brake light switch, align the
projection on the switch with the hole in the master
cylinder.
3
5
4
I718H1410053-01
6
7
I718H1410054-02
8 9
11
10
I649G1410023-02
I649G1410024-02
I718H1410055-01
To Next Page
Loading...
