ABS: 4E-16
ABS Component
Wheel speed sensor – sensor rotor clearance
inspection
Inspect the clearance between the wheel speed sensor
and sensor rotor for each wheel using the thickness
gauge.
Special tool
(A): 09900–20803 (Thickness gauge)
(B): 09900–20806 (Thickness gauge)
Wheel speed sensor – Sensor rotor clearance
0.3 – 1.5 mm (0.012 – 0.059 in)
Front
Rear
ABS control unit/HU ground wire inspection
1) Turn the ignition switch OFF.
2) Remove the seat. Refer to “Exterior Parts Removal
and Installation in Section 9D (Page 9D-6)”.
3) Disconnect the battery (–) lead wire.
4) Remove the left frame cover. Refer to “Exterior Parts
Removal and Installation in Section 9D (Page 9D-
6)”.
5) Remove the fuse box mounting bolt (1).
6) Disconnect the ABS control unit coupler (2).
(A), (B)
I718H1450025-01
(A), (B)
I718H1450026-01
I718H1450124-01
1
I718H1450028-01
2
I718H1450115-01
To Next Page
Loading...
