4E-33 ABS:
NOTE
• Inspect the rear brake in the same manner of front brake.
• If the ABS does not function, the cause may lie in the ABS control unit/HU.
• In checking the rear brake at the time of pressure reduction drive (4/7), “brake lever” appears on the
screen. This is because the present screen shares with other model having front brake only.
Therefore, in the case of rear brake pedal equipped vehicle, ignore this instruction and operate the
rear brake pedal.
7) Close the SDS tool and turn the ignition switch OFF.
8) Disconnect the SDS tool and install the right frame cover.
Return Finish Cancel Help
I718H1450062-01
To Next Page
Loading...
