5B-6 Manual Transmission:
Countershaft Assembly
• Apply grease to the O-rings.
CAUTION
!
Replace the O-rings (1) with new ones.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Align the punch marks “A” on the countershaft bearing
housing and bearing retainer.
• Apply a small quantity of thread lock to the bearing
retainer screw and tighten them to the specified
torque.
: Thread lock cement 99000–32110
(THREAD LOCK CEMENT SUPER 1322 or
equivalent)
Tightening torque
Countershaft bearing retainer screw (a): 12 N·m (
1.2 kgf-m, 8.5 lb-ft)
Gearshift Cam and Gearshift Fork
• Install the No.3 gearshift fork (1) as shown.
• Install the gearshift cam (2) with the bearing fitted.
• With engaging the fork end to the cam groove, insert
the fork shaft (3).
• With engaging each fork end to the cam groove, insert
the fork shaft (4).
1
I718H1520085-01
(a)
(a)
“A”
I718H1520021-02
1
I718H1520022-03
2
3
I718H1520023-01
4
I718H1520024-01
To Next Page
Loading...
