Engine General Information and Diagnosis: 1A-30
P0105-H for IAP sensor (No.1) (Use of SDS)
Step Action Yes No
1 1) Click the data monitor button (1).
2) Check the manifold absolute pressure 1 data.
Approx. 146 kPa (1.46 kgf/cm
3
, 21 psi) and more OK?
Go to Step 2. Go to Step 4.
2 1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-9)”.
3) Check the IAP sensor (No.1) coupler for loose or poor
contacts.
If OK, then check the IAP sensor (No.1) lead wire
continuity.
Go to Step 4. W/Bl wire shorted to
Vcc, or B/Br wire open.
1
I718H1110251-01
I718H1110161-02
I718H1110257-01
To Next Page
Loading...
