Svantek SV 977D - Page 210

210
SV 977D User Manual - Appendixes
Word
number
Name
Comment
8
RepCycle
number of measurement cycles (zero means infinity) - the parameter
is important if the duration of the measurement cycle (IntTimeSec) is
finite; for infinite measuring cycle time this parameter is irrelevant
(see SplitCycles)
9
NofProf
number of measurement profiles
10
StartDelay
measurement start delay in seconds
11..12
IntTimeSec
duration of one measurement cycle in seconds (zero means infinity)
13
StartSync
measurement start synchronization:
0 – no synchronization
1 – synchronization to full minute
15 – synchronization to full 15 minutes
30 – synchronization to full 30 minutes
60 – synchronization to full hour.
14
RmsInt
detector type for RMS/Leq results:
0 – measurement with linear detector
1 – measurement with exponential detector.
15
SpecLogg
bit mask of logged spectra results:
8 – RMS/Leq spectrum (applies to octave spectra)
8 – average spectrum (applies to FFT spectrum)
the remaining masks are reserved
16
SummaryResLog
bit mask of logged cyclic results (Summary Results):
1 – Main Results
2 – Statistical Levels,
4 – Spectrum,
8 – Spectrum Max,
16 – Spectrum Min,
32 – Spectrum Peak,
64 – Statistical analysis in profiles
128 – Statistical analysis in spectrum
256 – RPM
512 – Meteo
other masks are reserved
17
ExposureTime
exposure time in minutes (sound mode only)
18
RefAcc/LR1Time
for vibration measurement mode:
– value of reference vibration acceleration in 0.01dB relative to
1μm/s
2
for sound measurement mode:
– „Rolling Leq’s” first result in seconds
19
RefVel/LR2Time
for vibration measurement mode:
– value of reference vibration speed at 0.01dB relative to
1nm/s
for sound measurement mode
– Second „Rolling Leq’s” score in seconds
20
RefDil
for vibration measurement mode:
– value of reference vibration displacement at 0.01dB relative
to 1pm
for sound measurement mode:
– reserved value