SYSMEX XE-5000 - File Information

CHAPTER 7 Quality control
7-22 Sysmex XE-5000 Instructions for Use
Revised April 2007
7.11 File Information
A list of the file information can be displayed according to
analysis type.
1. Start quality control from the Information Processing Unit
(IPU).
2. Click the “File Info.” button.
The QC File Information dialog box will appear.
3. When two or more Main Units are connected to one IPU,
click the Inst. ID combo box and select the instrument in
which you wish to display a list of file information.
4. Click the Mode combo box, and select the analysis mode
in which you wish to display a list of the file information.
5. Click “Close” to close the dialog box.
Note:
It is impossible to change the file information on the
File Information screen.
To set or change the file information, see “Chapter 7:
7.8 Lot No.”.