SYSMEX XE-5000 - Chapter 13 Index

CHAPTER 13 Index
Sysmex XE-5000 Instructions for Use 13-1
Revised July 2007 EU
13. Index
A
Additional components .........................................5-2
Adjusting pressure and vacuum .........................9-46
Adjusting the pressure to 0.03 MPa....................9-49
Adjusting the pressure to 0.07 MPa....................9-48
Adjusting the pressure to 0.16 MPa....................9-48
Adjusting the pressure to 0.25 MPa....................9-47
Adjusting the vacuum to 0.04 MPa.....................9-50
Alarm sound..........................................................6-6
Analysis mode ...........................................3-17, 6-12
Analysis result output..........................................6-26
Auto output settings check..................................6-11
Auto setting (Target/Limit) ..................................7-19
Automatic calibration ............................................8-2
Avoidance of infection...........................................2-3
B
Background check ..............................................6-10
Barcode (Test)..................................................10-35
Basic equipment settings......................................5-3
Before Using.........................................................5-1
Body fluid analysis..............................................6-33
C
Calibration.............................................................8-1
Calibration execution timing..................................8-1
Calibration history.................................................8-9
CELLCLEAN.........................................................4-6
CELLPACK...........................................................4-1
CELLSHEATH ......................................................4-1
Change lot ..........................................................7-13
Check before installation ..................................11-36
Cleaning and Maintenance...................................9-1
Cleaning the flow cell in the optical detector block 9-17
Cleaning the IMI detector aperture .....................9-12
Cleaning the manual rinse cup .............................9-7
Cleaning the piercer tray.....................................9-10
Cleaning the RBC detector aperture...................9-14
Cleaning the sample rotor valve ...........................9-4
Cleaning the sample rotor valve tray....................9-9
Closing the XE-5000 application.........................6-41
Computer viruses................................................2-12
Conditions for sample analysis...........................6-12
Contents of the packages.................................11-32
Control blood (e-CHECK(XE))..............................4-7
CP Unit (Test)...................................................10-35
D
Deleting QC data...................................................7-9
Design and Function.............................................3-1
Detection principle.............................................11-11
Display analysis results.......................................6-25
Display order.......................................................7-21
Displaying the last sample data ............................8-6
Displaying the pressure or vacuum.....................9-46
Displaying the reagent setting screen.................9-19
Disposal of waste fluids, disposables and
instruments........................................................2-6
E
Electrical system block diagram........................11-31
Electromagnetic compatibility (EMC) ....................2-3
Error log ..............................................................10-1
Error message list...............................................10-3
Execution of shutdown..........................................9-2
F
File Information ...................................................7-22
G
General information...............................................2-1
General information (Reagents)............................4-1
Grounding .........................................................11-36
H
Handling of reagents.............................................2-4
Hazard information in this manual.........................1-3
HELP screen.......................................................10-1
HPC analysis.......................................................6-27
Hydraulic system block diagram .......................11-14
I
Information Processing Unit (IPU).......................3-14
Information Processing Unit (IPU) menu bar ........6-5
Installation.............................................................2-2
Installation environment ....................................11-36
Installation space ..............................................11-37
Interface protocol ..............................................11-10
Introduction ...........................................................1-1