CHAPTER 9 Cleaning and Maintenance
Sysmex XE-5000 Instructions for Use 9-31
Revised April 2007 EU
9. When connecting, make sure the quick connector collar is
pulled all the way up and gently insert all the way over the
cubitainer spout and then release collar. Verify that
connector is sealed by gently lifting up on quick connector.
If inserting the quick connector to the spout is difficult, wet
both the connection ports again with a lint-free gauze
moistened with alcohol and try again.
10. Check that the container is connected securely.
11. Press the HELP key on the Main Unit panel keypad. The
HELP screen will appear.
12. If you select “OK” on the function menu of the HELP
screen, the Reagent setting screen will appear.
See “Chapter 9: 9.13 Replacing and registering reagents”
for explanation of the Reagent setting screen.
9.14 Reagent replacement log display function
This function displays,on the Information Processing Unit
(IPU), the replacement history for the reagents registered with
the reagent registration function. See “Chapter 9: 9.13
Replacing and registering reagents” for explanation of the
reagent registration function.
Comments can be added to the data stored in the reagent
replacement log. The log information can be printed out using
a Ledger printer and output in a csv file.
Caution!
• Take care not to spill a reagent.If it spills, wipe it off
immediately using a wet cloth or the like.
The floor could be stained.
• Check that the one-touch coupling is connected
securely to the reagent container.
Analysis may not be performed correctly if the
coupling is not connected correctly.
• After connecting the new reagent container, do not
detach the one-touch coupling until the next time the
reagent must be replaced.
Otherwise, analysis may not be performed correctly.
SHUTDOWN HELP
SAMPLER
RETURN MORE
NUM./ALPH. ENTER
MANUAL
QZ
0 -/. C
PRS
1
TUV
2
WXY
3
GHI
4
JKL
5
MNO
6
7
ABC
8
DEF
9
To Next Page
Loading...
