SYSMEX XE-5000 - Page 261

CHAPTER 13 Index
Sysmex XE-5000 Instructions for Use 13-3
Revised July 2007 EU
S
Safety Information.................................................2-1
Sample analysis in capillary mode......................6-19
Sample analysis in manual mode.......................6-17
Sample analysis in manual closed mode............6-24
Sample analysis in sampler mode......................6-21
Sampler (Test)..................................................10-33
Sampler Unit.......................................................3-13
Samples used for calibration ................................8-1
Save....................................................................7-10
Self-checks ...........................................................6-9
Shutdown............................................................6-39
Shutting down the Windows system...................6-41
Specified conditions of use...................................2-1
SRV (Test)........................................................10-38
Status................................................................10-30
Storage prior to transport and installation.............5-1
STROMATOLYSER-4DL......................................4-2
STROMATOLYSER-4DS .....................................4-3
STROMATOLYSER-4DS (FFS) replacement
procedure ........................................................9-24
STROMATOLYSER-FB........................................4-2
STROMATOLYSER-IM ........................................4-5
STROMATOLYSER-IM (SIM) replacement
procedure ........................................................9-29
STROMATOLYSER-NR(L)...................................4-3
STROMATOLYSER-NR(L) &
STROMATOLYSER-NR(S)(SNR)
replacement procedure ...................................9-25
STROMATOLYSER-NR(S) ..................................4-4
SULFOLYSER......................................................4-4
Summary of information processing unit (IPU)
operation ...........................................................6-4
Summary of Main Unit operation ..........................6-1
Summary of the Information Processing Unit (IPU)
display screen .................................................3-16
Supplies and replacement parts .........................9-51
Symbols used on the labels..................................4-8
T
Target/Limit.........................................................7-16
Technical Information .........................................11-1
Test...................................................................10-30
Timer processing ................................................6-38
Troubleshooting..................................................10-1
Troubleshooting (QC) .........................................7-12
Troubleshooting guide ........................................10-9
Turning ON the power ..........................................6-8
V
Variable target ....................................................7-17
W
Warranty .............................................................12-1
WBC differential analysis..................................11-21
WBC classification............................................11-18
X
X-barM control setting...........................................7-3
XE-5000 maintenance and inspection
check list..........................................................9-50