SYSMEX XE-5000 - Chapter 1 Introduction

Table of Contents
Sysmex XE-5000 Instructions for Use III
Revised April 2007 EU
Chapter 8 Calibration ...................................8-1
8.1 Calibration execution timing...................................... 8-1
8.2 Samples used for calibration .................................... 8-1
8.3 Reference values...................................................... 8-1
8.4 Automatic calibration ................................................ 8-2
8.5 Displaying the last sample data................................ 8-6
8.6 Manual calibration .................................................... 8-6
8.7 Calibration history..................................................... 8-9
Chapter 9 Cleaning and Maintenance.........9-1
9.1 Execution of shutdown ............................................. 9-2
9.2 Removing fluid from the Pneumatic Unit
trap chamber ............................................................ 9-3
9.3 Cleaning the sample rotor valve............................... 9-4
9.4 Cleaning the manual rinse cup................................. 9-7
9.5 Cleaning the sample rotor valve tray ........................ 9-9
9.6 Cleaning the piercer tray ........................................ 9-10
9.7 Removing clogs (clog removal sequence).............. 9-11
9.8 Cleaning the IMI detector aperture.........................9-12
9.9 Cleaning the RBC detector aperture ...................... 9-14
9.10 Removing air bubbles from the flow cell in the optical
detector block ......................................................... 9-17
9.11 Cleaning the flow cell in the optical
detector block ......................................................... 9-17
9.12 Replacing the waste container (option) ..................9-18
9.13 Replacing and registering reagents........................ 9-19
9.14 Reagent replacement log display function.............. 9-31
9.15 Remaining reagent volume function....................... 9-36
9.16 Replacing the piercer ............................................. 9-38
9.17 Replacing the hand clipper.....................................9-41
9.18 Replacing rubber plate No. 39................................ 9-43
9.19 Replacing the fuses................................................ 9-44
9.20 Replacing the HEPA filter (option) .......................... 9-45
9.21 Adjusting pressure and vacuum ............................. 9-46
9.22 Supplies and replacement parts............................. 9-51
9.23 XE-5000 maintenance and inspection check list.... 9-52
Chapter 10 Troubleshooting........................ 10-1
10.1 HELP screen .......................................................... 10-1
10.2 Error log.................................................................. 10-1
10.3 Error message list .................................................. 10-3
10.4 Troubleshooting guide ............................................ 10-9
10.5 Test....................................................................... 10-30