CHAPTER 6 Operation
Sysmex XE-5000 Instructions for Use 6-7
Revised July 2007 EU
● Samples Analyzed per Reagent Container
• The number of cycles per container refers to the number of
cycles that can be run in CBC+DIFF+RET+NRBC analysis
mode.
● Replacing the Reagent
After replacement of the reagent, perform automatic cleaning,
check that the background count is low, then start the sample
analysis.
Reagent Abbreviation
No. of cycles/
container
Capacity
per
container
CELLPACK EPK Approx. 660
cycles
20.0 L
CELLSHEATH ESE Approx. 7300
cycles
20.0 L
STROMATOLYSER-
FB
FBA Approx. 2750
cycles
5 L
STROMATOLYSER-
4DL
FFD Approx. 2750
cycles
5 L
STROMATOLYSER-
4DS
FFS Approx. 2000
cycles
42 mL
STROMATOLYSER-
NR(L)
SNR Approx. 2000
cycles
3.6 L
STROMATOLYSER-
NR(S)
Approx. 2000
cycles
43 mL
SULFOLYSER SLS Approx. 10000
cycles
5 L
STROMATOLYSER-
IM
SIM Approx. 3200
cycles
10 L
RET SEARCH (II)
(Diluent)
RED Approx. 550
cycles
1 L
RET SEARCH (II)
(Dye solution)
Approx. 550
cycles
12 mL
Caution!
• Use reagent that has been left at room temperature
(15–30°C) for at least 24 hours.
• In handling a reagent that may have frozen, follow
the precautions given on the package.
Otherwise analysis may not be performed correctly.
• When replacing the reagent container, make sure
that no dust adheres to the cubitainer spout kit.
Otherwise analysis may not be performed correctly.
• After opening a reagent container, make sure that no
dust, dirt or bacteria comes into the container.
Otherwise analysis may not be performed correctly.
To Next Page
Loading...
