Attendant Features 199 FlexSet 120S/280S User Guide
System Features
[XfrD/N] Day/Night Transfer toggle feature. Press [XfrD/N] to switch from automatic to manual transfer between
the various Day/Night service modes and back again. When set to Auto Transfer, a bullet is displayed
next to [XfrD/N].
When set to Automatic, the system will transfer service modes without attendant supervision.
When set to Manual, the attendant must decide when to change modes using the [Day/N1] and [Day/N2] soft
keys (see below).
[Day/N1] Day/Night 1 toggles between Day (normal mode) and Night 1 service modes. When set to Night 1, a
bullet is displayed next to [Day/N1].
[Day/N2] Day/Night 2 toggles between Day (normal mode) and Night 2 service modes. When set to Night 2, a
bullet is displayed next to [Day/N2].
Use the table below to enter the relevant information concerning Day/Night Transfer. Contact your
system administrator for Day/Night Transfer times and destinations.
Day/Night Transfer Information
Service
Mode
Start Time
(for automatic transfer)
Incomplete Calls
Destination
Intercept Calls
Destination
COS
Primary/Secondary
DAY
NIGHT 1
NIGHT 1
To Next Page
Loading...
