Attendant Features 201 FlexSet 120S/280S User Guide
System Features
The following table defines the special codes that may be used as part of the outside number.
CODES DESCRIPTION
*x Delay dialing by X seconds (x = 1 to 9)
#0 Stop dial (end of outside or network number)
#1 Outpulsing wait period during which user is able to dial any number of digits
#2 All digits following will be Dial Pulse
#3 All digits following will be DTMF
#4 Inhibits display (for Call Accounting System and key set display)
#5 Enables display (for Call Accounting System and key set display)
#6 Wait for second dial tone
#8 Display ‘_’ (for Call Accounting System and key set display)
#9 Calibrated Opening on trunk (FlashTk)
** Dial * out
## Dial # out
NOTE: The number of digits that can be programmed, including dial codes, is limited by the
Coral (defined system-wide). Should you try entering a longer digit string than allowed
the system will give the error message LENGTH EXCEEDED, and programming will
stop.
To Next Page
Loading...
