Tally T8024 - Power Saver

5.3 List of Menu Items
118
5
Control Panel
If the "Power Saver Mode" is set to "Disabled", the printer does not go into that power saver
mode.
The table below describes the situations when the printer is released from the power saver
modes. By default, "Power Saver Mode 2" is "Disabled". The printer does not switch to power
saver mode 2 unless you set it to do so.
When an optional network expansion card is installed, the printer will not switch to power
saver mode 2.
●
Mode 1 (default: 3 minutes)
Set a time between 1 and 120 minutes. The printer automatically goes into power saver
mode 1 when it is idle for the duration set here.
●
Mode 2 (default: 5 minutes)
Set a time between 5 and 120 minutes. The printer automatically goes into power saver
mode 2 after being in power saver mode 1 for the duration set here.
"Mode 2" is not displayed when an optional network expansion card is installed.
Power Saver
Set this for each mode to determine if the printer goes into power saver mode.
The printer does not go into power saver mode when it is "Disabled".
●
Mode 1 (default: Enabled)
●
Mode 2 (default: Disabled)
"Mode 2" is not displayed when an optional network expansion card is installed.
Release from power saver mode 1
Release from power saver mode 2
(When the optional network expansion card is not installed)
●
When receiving print data.
●
When printing a report or list with "4:
Report/List".
●
When the menu screen is quit
●
When pressing the Power saver button on the control
panel.
●
When receiving print data via the network.
●
When accessing the printer via the network.
●
When accessing the printer via the network utility.
●
When searching for the printer with Internet Services.
●
When accessing the printer with Simple Status
Notification.
●
When the computer accesses the printer via the network.