Tally T8024 - Network

5.3 List of Menu Items
124
5
Control Panel
5.3.5 Network
Use this to make network settings. Some network settings are only displayed
when an optional network expansion card is installed.
●
It is not possible to set items in this menu while printing.
●
You must restart the printer for this setting to take effect. After configuring items, be sure to
restart the printer.
Ethernet
Use this to set Ethernet communication speed and mode.
●
Auto (default)
10Base-T Half, 10Base-T Full, 100Base-TX Half, or 100Base-TX Full is selected
automatically.
●
10Base/Half
●
10Base/Full
●
100Base/Half
●
100Base/Full
TCP/IP
Use this to make TCP/IP settings. This menu contains the following:
●
IP Address Setup
Select the how to obtain an IP address. Parameters are as follows:
DHCP (default)
The IP address is obtained from a DHCP server on the network.
Panel
Use this to set the IP address from the control panel.