Tally T8024 - Setting the Protocols

1.2 Configuring the Printer
16
Printer System Settings
1
1.2.4 Setting the Protocols
When the printer is shipped from the factory, all protocols except "FTP" are "Enabled" by
default. You do not need to perform the operations described in this section when you
connect a new printer to a network for the first time.
This concludes the Printer Settings list. Move on to "1.2.5 Checking Settings".
When you want to use the printer as a network printer, you need to set the right
protocols on the printer.
●
For TCP/IP(LPD) → "LPD" protocol
●
For Port 9100 → "Port9100" protocol
●
For IPP → "IPP" protocol
●
For SMB (transport protocol: TCP/IP) → "SMB TCP/IP" protocol
●
For SMB (transport protocol: NetBEUI) → "SMB NetBEUI" protocol
●
For NetWare → "NetWare" protocol
Follow the procedure below.
If you do not have an optional network expansion card, the following protocols do not appear:
●
SMB TCP/IP
●
SMB NetBEUI
●
NetWare
●
IPP
●
Ethertalk
●
SNMP IPX
Refer to "5.2 Basic Menu Operation" and "Appendix B Control Panel Menu List" for
information about the operation of the control panel.