Tally T8024 - Page 152

5.3 List of Menu Items
126
5
Control Panel
●
802.3
Set this to use IEEE 802.3 frame type.
●
802.2
Set this to use IEEE 802.3/802.2 frame types.
●
SNAP
Set this to use IEEE 802.3/802.2/SNAP frame types.
●
Ethernet-II
Set this to use Ethernet-II frame type.
Protocol
Set "Enabled" or "Disabled" for each item activate or deactivate them.
The items below marked with a "*" are only displayed when an optional network expansion
card is installed.
●
LPD (default: Enabled)
When using TCP/IP, set "LDP" to "Enabled" to print with LPD (LPR) or to "Disabled" if you
do not want to use this feature.
●
Port9100 (default: Enabled)
When using TCP/IP, set "Port9100" to "Enabled" to print with port 9100 (Raw Data Socket)
or to "Disabled" if you do not want to use this feature.
●
IPP (default: Enabled)*
When using TCP/IP, set "IPP" to "Enabled" to print with IPP (Internet Printing Protocol) or
to "Disabled" if you do not want to use this feature. Available with Windows 2000, Windows
XP, and Windows Me.
●
SMB TCP/IP (default: Enabled)*
When using SMB (Windows network) with TCP/IP as the transport protocol, set "SMB
TCP/IP" to "Enabled" to print using SMB or to "Disabled" if you do not want to use this
feature.
●
SMB NetBEUI (default: Enabled)*
When using SMB (Windows network) with NetBEUI as the transport protocol, set "SMB
NetBEUI" to "Enabled" to print using SMB or to "Disabled" if you do not want to use this
feature.
●
Ethertalk (default: Enabled)*
Set "Ethertalk" to "Enabled" to print in an Apple system with the Postscript option installed
in the printer or to "Disabled" if you do not want to use this feature.
●
NetWare (default: Enabled)*
Set "NetWare" to "Enabled" to print in a NetWare system or to "Disabled" if you do not want
to use this feature.
●
FTP (default: Disabled)
When using TCP/IP, set "FTP" to "Enabled" to print with FTP (File Transfer Protocol) or to
"Disabled" if you do not want to use this feature.