Tally T8024 - Page 177

6.6 Other Problems
151
6
Troubleshooting
There is
condensation in the
printer
- On the control panel, set the Power
Save Mode Timer to one hour or more
and leave the printer on.
After leaving the printer for an hour to
allow condensation to dissipate, you can
use the printer normally.
"5.3 List of Menu Items"
The printer does
not switch to power
saver mode 2
(When an optional
network expansion
card is not
installed)
Is "Disabled" selected from the control
panel for switching to power saver
mode 2?
Select "Enabled" from the control panel
for switching to power saver mode 2.
Is it set to startup the Simple Status
Notification when the computer is
started?
Set the time for the Simple Status
Notification to access the printer longer
than the time to shift to the power saver
mode.
Symptom Possible Cause Action