Technicolor TG670 User Manual

PWR COMMANDS
846
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
pwr debug traceconfig
Enable/disable the ECO manager traces
SYNTAX:
pwr debug traceconfig [state = <{disabled|enabled}>]
Configures the protocol independent
information. = <{disabled|enabled}>
where:
state enable/disable the ECO manager tracesCommand: router
config
OPTIONAL
Configures the protocol independent
information.
Syntax : config [as = <number>] [routerid = <ip-address>]
[syslog_emerg = <{disabled|enabled}>] [syslog_alert =
<{disabled|enabled}>] [syslog_crit = <{disabled|enabled}>]
[syslog_error = <{disabled|enabled}>] [syslog_warning =
<{disabled|enabled}>] [syslog_notice = <{disabled|enabled}>]
[syslog_info = <{disabled|enabled}>] [syslog_debug =
<{disabled|enabled}>]
REQUIRED
SYNTAX:
pwr debug traceconfig [as = <number>]
[routerid = <ip-address>]
[syslog_emerg = <{disabled|enabled}>]
[syslog_alert = <{disabled|enabled}>]
[syslog_crit = <{disabled|enabled}>]
[syslog_error = <{disabled|enabled}>]
[syslog_warning = <{disabled|enabled}>]
[syslog_notice = <{disabled|enabled}>]
[syslog_info = <{disabled|enabled}>]
[syslog_debug = <{disabled|enabled}>]
where:
as Sets the autonomous system number OPTIONAL
routerid The router identifier for use by the BGP and OSPF OPTIONAL
syslog_emerg Specifies whether or not to log messages with level
LOG_EMERG
OPTIONAL
syslog_alert Specifies whether or not to log messages with level
LOG_ALERT
OPTIONAL
syslog_crit Specifies whether or not to log messages with level
LOG_CRIT
OPTIONAL
syslog_error Specifies whether or not to log messages with level
LOG_ERROR
OPTIONAL
nickdj.co.uk

Technicolor TG670 Specifications

General

Brand	Technicolor
Model	TG670
Category	Network Router
Language	English