ATM COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
75
atm qosbook ctdadd
Add a new connection traffic descriptor.
SYNTAX:
atm qosbook ctdadd name = <string>
conformance = <{UBR|CBR|VBR|UBR.1|UBR.2|
UBR.mdcr|CBR.1|VBR.1|VBR.2|VBR.3|VBR.c|VBR.nt|
VBR.t|GFR.1|GFR.2}>
[peakrate = <number{0-27786}>]
[sustrate = <number{0-27786}>]
[maxburst = <number{48-12240}>]
[minrate = <number{0-27786}>]
[maxframe = <number{0-255}>]
[celldelay = <number>]
[realtime = <{enabled|disabled}>]
[framediscard = <{enabled|disabled}>]
where:
name The name for the new CTD entry. REQUIRED
conformance The ATM service conformance definition. REQUIRED
peakrate The peak rate (in kilobits per second). Use '0' to indicate
linerate for UBR.
OPTIONAL
sustrate The sustainable rate (in kilobits per second). (VBR only) OPTIONAL
maxburst The maximum burst size (in bytes). (VBR or GFR) OPTIONAL
minrate The minimum rate (in kilobits per second). (UBR.m or GFR) OPTIONAL
maxframe The maximum frame size (in bytes). (GFR only) OPTIONAL
celldelay Cell delay variation in tenths of microseconds. OPTIONAL
realtime Enable/disable realtime traffic (VBR only). OPTIONAL
framediscard Enable/disable frame discard. OPTIONAL
To Next Page
Loading...
Need help?
General
