SYSTEM COMMANDS
1064
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
system config
Set or change system config parameters.
SYNTAX:
system config [upnp = <{disabled|enabled}>]
[tr64 = <{disabled|enabled}>]
[tr64sessiontimeout = <number{30-45}>]
[tr64auth = <{disabled|enabled}>]
[mdap = <{disabled|enabled}>]
[led = <{blue|green|red|orange|flash|off}>]
[resetbutton = <{disabled|enabled}>]
[defaultconnection = <{loop|Internet|lan1|
wan1|dmz1|guest1}>]
[autosave = <{enabled|disabled}>]
[autosavedelay = <number{0-600}>]
[WANMode = <{ADSL|VDSL|SHDSL|ETH|UMTS}>]
[WANEthPort = <{ethif1|ethif2|ethif3|ethif4|
ethif5}>]
where:
upnp Enable/Disable upnp discovery OPTIONAL
tr64 Enable/Disable TR-64 discovery OPTIONAL
tr64sessiontimeout TR-64 session timeout value (sec) OPTIONAL
tr64auth Enable/Disable TR-64 digest authentication OPTIONAL
mdap Enable/Disable mdap discovery OPTIONAL
led Set system LED color OPTIONAL
resetbutton Enable/Disable reset-to-factory-defaults pushbutton OPTIONAL
defaultconnection The name of the default internet connection. OPTIONAL
autosave Enable/Disable autosaves OPTIONAL
autosavedelay Autosave delay in seconds (0 for immediate save) OPTIONAL
WANMode Set autosensing wan mode OPTIONAL
WANEthPort Set autosensing eth wan port OPTIONAL
To Next Page
Loading...
Need help?
General
