Technicolor TG670

IP COMMANDS
582
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ip ifconfig
Modify an IP interface configuration.
SYNTAX:
ip ifconfig intf = <{loop|ipsec0|Internet|lan1|wan1|dmz1|
guest1}>
[mtu = <number{68-65535}>]
[status = <{down|up}>]
[hwaddr = <hardware-address>]
[arpcachetimeout = <number{0-7200}>]
[group = <{wan|local|lan|tunnel|dmz|guest} or
number>]
[linksensing = <{disabled|enabled}>]
[primary = <{disabled|enabled}>]
[mcastpromisc = <{disabled|enabled}>]
[symmetric = <{disabled|enabled}>]
[arpprobe = <{unicast|broadcast}>]
where:
intf An IP interface name. REQUIRED
mtu The maximum packet size (including IP header) to use on
this interface.
OPTIONAL
status The administrative state of the interface. OPTIONAL
hwaddr The hardware address (e.g. Ethernet MAC address) of this
interface.
OPTIONAL
arpcachetimeout Set the ARP cache timeout to be used for this interface (0 =
use global ARP cache timeout).
OPTIONAL
group The group this interface belongs to. Can be used by e.g.
firewalling.
OPTIONAL
linksensing The IP interface's awareness of link state transitions. OPTIONAL
primary Make the IP interface the primary interface. OPTIONAL
mcastpromisc Make the IP interface multicast promiscuous. OPTIONAL
symmetric The routing mode of the IP interface. OPTIONAL
arpprobe The ARP mode of the interface. OPTIONAL
nickdj.co.uk