ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
423
eth filter operand reset
Reset an operand to its default initial state (removes all content, set to
SYNTAX:
eth filter operand reset operand = <{}>
where:
operand The name of an operand. REQUIRED
To Next Page
Loading...
Need help?
General
