SLA COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
963
sla traceroute stop
Stop traceroute test operation
SYNTAX:
sla traceroute stop test = <>
Configure global SNMP parameters. = <>
where:
test The name of a test.Command: snmp config REQUIRED
Configure global SNMP parameters. Syntax : config [sysContact = <quoted string>] [sysName
= <quoted string>] [sysLocation = <quoted string>] [traps
<{disabled|enabled}>]
REQUIRED
SYNTAX:
sla traceroute stop [sysContact = <quoted string>]
[sysName = <quoted string>]
[sysLocation = <quoted string>]
[traps = <{disabled|enabled}>]
where:
sysContact SNMP System Contact OPTIONAL
sysName SNMP System Name OPTIONAL
sysLocation SNMP System Location OPTIONAL
traps Disable or enable sending of SNMP traps. OPTIONAL