Technicolor TG670 - Sla Traceroute Modify

SLA COMMANDS
960
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
sla traceroute modify
Modify traceroute test configuration
SYNTAX:
sla traceroute modify test = <>
[addr = <string>]
[size = <number{0-20000}>]
[timeout = <number{1-60}>]
[probePerHop = <number{1-10}>]
[port = <number{1-65535}>]
[maxTtl = <number{1-255}>]
[initTtl = <number{0-255}>]
[createHopEntries = <{disabled|enabled}>]
[frequency = <number{0-65535}>]
[maxrow = <number{0-100}>]
[storagetype = <{volatile|nonVolatile}>]
[trap = <[+/-]flag[+/-flag...]{pathChange
testFailure testCompletion}>]
[type = <{IcmpEcho|UdpEcho}>]
[descr = <quoted string>]
[srcaddr = <ip-address>]
[intf = <{none|loop|ipsec0|Internet|lan1|wan1|
dmz1|guest1|>]
[maxfail = <number{0-255}>]
[bypassrt = <{disabled|enabled}>]
[dffield = <{disabled|enabled}>]
[dsfield = <number{0-255}>]
where:
test The name of the traceroute test to configure. REQUIRED
addr The destination IP address. OPTIONAL
size The size of the data portion to be transmitted in a traceroute
request.
OPTIONAL
timeout The timeout value, in seconds, for a traceroute request OPTIONAL
probePerHop The number of times to reissue a traceroute request with the
same time-to- live value .
OPTIONAL
port The UDP destination port number to send to. OPTIONAL
maxTtl The upper limit on the number of routers through which a
packet can pass.
OPTIONAL
initTtl The initial time-to-live value. OPTIONAL
createHopEntries Enables creation of traceroute hop table. OPTIONAL
frequency The number of seconds to wait before repeating a
traceroute test.
OPTIONAL
nickdj.co.uk