ROUTER COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
883
router ospf debug traceconfig
Configures the OSPF daemon tracepoints.
SYNTAX:
router ospf debug traceconfig [all = <{disabled|enabled}>]
[normal = <{disabled|enabled}>]
[policy = <{disabled|enabled}>]
[task = <{disabled|enabled}>]
[timer = <{disabled|enabled}>]
[route = <{disabled|enabled}>]
where:
all Enable/Disable tracing of all events related with OSPF OPTIONAL
normal Enable/Disable tracing of normal protocol occurrences OPTIONAL
policy Enable/Disable tracing the policy functions OPTIONAL
task Enable/Disable tracing the routing processing associated
with OSPF
OPTIONAL
timer Enable/Disable tracing the timer usage of OSPF OPTIONAL
route Enable/Disable tracing the RIB table changes for routes
installed by OSPF
OPTIONAL
To Next Page
Loading...
Need help?
General
