IPSEC COMMANDS
678
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ipsec peer vpnclient modify
Configures a VPN client configuration group
SYNTAX:
ipsec peer vpnclient modify name = <>
[xauthuser = <quoted string>]
[xauthpass = <password>]
[clienttype = <{generic|cisco|nortel}>]
[virtualip_map = <{nat|dhcp|none}>]
[lan_range = <ip-range>]
where:
name The name of the VPN client descriptor REQUIRED
xauthuser When using X-AUTH , the X-AUTH username. OPTIONAL
xauthpass When using X-AUTH , the X-AUTH password. OPTIONAL
clienttype Behaviour compatible with this vendor OPTIONAL
virtualip_map How to tie the Virtual IP address to a PC. OPTIONAL
lan_range Range of local client PC addresses which will be NATed
with Mode-Cfg address (applies to NAT mode only)
OPTIONAL
To Next Page
Loading...
Need help?
General
