ETH COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
479
eth switch storm ifconfig
Configure per port storm control parameters.
SYNTAX:
eth switch storm ifconfig port = <number{1-5}>
[state = <{enabled|disabled}>]
[rate = <number{0-1000}>]
[burstsize = <{16|20|28|40|76|140|268|500}>]
[broadcast = <{enabled|disabled}>]
[multicast = <{enabled|disabled}>]
[unknown = <{enabled|disabled}>]
where:
port The port. REQUIRED
state Enable/disable storm control. OPTIONAL
rate Rate in 10ths of percent. OPTIONAL
burstsize Burst size in KBytes. OPTIONAL
broadcast Storm control for broadcast traffic. OPTIONAL
multicast Storm control for multicast traffic. OPTIONAL
unknown Storm control for traffic with unknown destination address. OPTIONAL
To Next Page
Loading...
Need help?
General
